P1EC5 BMW Fault Code

Description:

Fuel Rail Pressure Sensor in Range But Low The comprehensive component monitor (CCM) monitors the FRP pressure for acceptable fuel pressure. The test fails when the fuel pressure falls below a calibrated value.

Low fuel pressure Damaged BMW FRP sensor Excessive resistance in circuit Low or no fuel A FRP PID value below 551 kpa (80 psi) indicates a failure Low or no fuel A FRP PID value greater than 896 kpa (130 psi) indicates a failure.

P1EC5 Code Symptoms :

The rule of P1EC5 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of P1EC5.

Likewise, overriding the OBD system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.

Diagnosis And Repairing P1EC5

P1EC5 OBD2 may also be triggered by faults earlier down the line. For example, a dirty MAF sensor might be causing the car to overcompensate in its fuel-trim adjustments. As a result, oxygen sensors are likely to report fuel mixture problems.

How to fix P1EC5 code ?

• 1Camshaft Position Sensor circuit poor electrical connection
• Faulty Mass Air Flow (MAF) sensor
• Faulty Mass Air Flow (MAF) sensor
• Erratic camshaft position due to low oil pressure

As the engine heats up and combustion becomes easier and more complete, the PCM will command the idling control valve to increase the amount of air entering the engine to suit the changing conditions.

However, when the load on the engine changes, say, when some electrical consumers or other systems are either turned on or off, the PCM adapts the signal voltage to the idle control valve to ensure that the idling speed remains stable, and at the RPM specified by the manufacturer.